Notes on configuring steel formwork

In our daily life, we often need to use steel template products, so we are using this kind What should you pay attention to when creating a template? Hubei Wangke Template Co., Ltd. provides the following suggestions for this problem:

1. When we are assembling steel templates, it is recommended to combine several common template specifications vertically and horizontally. Assemble, as much as possible to match the template area with 50mm as the module. Assuming that individual parts cannot meet the size requirements, the same thick wood template can be used to complement it.

2. Here, I want to make a suggestion with you. I suggest you use large-size steel templates as much as possible. The main board, in this way, can reduce splicing, save parts man-hours, enhance assembly rigidity, and facilitate mold removal.

3. The order of installing templates is usually bottom-up. According to strict requirements, each template requires the correct position, smooth surface, tight connection parts, and tight seams. If necessary, putty can be used to seal the gaps. In addition, everyone needs to pay attention to that the U-shaped cards on the same seam should be set up in the same direction at intervals between the forward and reverse directions to prevent the overall deformation of the steel template.

4. Everyone does not know that the installation of the column template is particularly prone to inaccurate cross-sectional dimensions. So, how can this be prevented? We can correct the position of the steel bars according to the ink line before supporting the mold, and nail the presser foot plate. In addition, we can also set a connecting corner mold at the corners, which is helpful to ensure the accuracy of the angle.

The installation of steel formwork support shall comply with the following regulations:

1, according to the steel template design and orderly assembly to ensure the overall stability of the template system.

2. The accessories must be installed firmly, and the supporting surface of the support and diagonal bracing should be flat and padded, and sufficient The compressed area.

3. The embedded parts and reserved holes must be positioned accurately and installed firmly.

4. The base steel template must be firmly supported to prevent deformation, and the bottom of the side form oblique support should be provided with skids .

5. The bottom surface of the wall and pillar template should be leveled, and the bottom end should be close to the pre-made positioning datum. Reliable support points should be provided when steel formwork continues to be installed on walls and columns, and its straightness should be corrected.

6. When supporting the slab formwork, the horizontal support and diagonal support of a structure should be completed first, and then gradually Expand outwards to maintain the stability of the system.

7. After the pre-assembled strong steel formwork is hoisted, the lower end should be leveled up, close to the positioning datum, on both sides The verticality of the template should be adjusted and fixed by diagonal bracing.

8. The horizontal brace and scissor brace of the pillars should be arranged according to the structure and overall stability;

9. Tell everyone that the pillars of multi-layer support should be set on the same vertical centerline. The lower floor slab should have the bearing capacity to withstand the load of the upper floor or add support, and the column of the lower support should be laid with pads.