Do you know the safety requirements for table form construction

When using table model construction, Hubei Wangke template A limited company should comply with the current safety technical specifications, but also need to take the following safety measures:

(1) Assembled table model. Try to carry out a pressure test before use to check that there are no hidden dangers in all parts.

(2) After the table model is in place, a guard rail should be set on the outside of the table model immediately, and the height can be as required It is confirmed, but not less than 1.2m. A safety net must be added to the outside, and guardrails on the floor must be set up at the same time.

(3) Before construction and material loading, all supports should be supported, and the construction load should be strictly controlled. Feeding should not be too much or too concentrated, and accounting should be done when necessary.

(4) When lifting the table model, the command should be unified, the step should be consistent, the signal should be clear, and the walkie-talkie should be used as much as possible to communicate . All operators must be specially trained to operate.

(5) The upper and lower signal labor should be clearly divided. The signal worker below can be responsible for the signals for the launching of the table model, controlling the ground rollers, hanging safety ropes and hooks, removing the safety rope and lifting; the signal worker above can be responsible for the adjustment of the balance spreader, the signal of the podium model in place and unhooking .

(6) When the table mold is exited with ground rollers, the front roller should be 1~2cm higher than the rear roller , To prevent the table mold from sliding outwards. The center of gravity of the table mold can be marked on the side of the table mold. It is strictly forbidden to tilt the table mold outwards before the outer lifting points are not hooked.

(7) When the table model is pushed out, a safety rope must be hung up and controlled by a dedicated person. The safety rope should be loosened slowly, and one end should be fixed to a reliable part of the building.

(8) When the hook worker is operating on the table model, he must wear a seat belt and hang it on the upper Embedded parts. Workers who hook the hook are not allowed to wear plastic shoes or hard-soled shoes to prevent slip and fall injuries.

(9) When the table is hoisted, no one is allowed to stand on the table. The personnel operating the electric balance spreader should also stand on the floor. It is necessary to wait for the table mold to be fully balanced before lifting, the tower crane jib must be slow, and it is not allowed to tilt the hanging mold.

(10) In case of strong wind or heavy rain above grade 5, the lifting of the table mold should be stopped.

(11) When hoisting the table model, you must use a safety ring instead of a hook. When lifting, all accessories of the table mold should be fixed in advance, and free materials are not allowed to be stored on the table mold. To prevent objects falling from high altitude and hurting people.

(12) When the table model is released, a safety net must be set up on the lower level. Especially when using roller bars to eject the mold, more attention should be paid to prevent the roller bars from falling.

(13) When electric welding is used on the bamboo board surface, asbestos cloth should be placed around the solder joints. After extinguishing the fire extinguishing species.

(14) After a certain stage of construction of the table model, check carefully whether all parts are damaged, and at the same time All fasteners are reinforced at one time.